CBT IT Certification Training

Unlimited IT Certification Courses via Streaming Video

reviewthanks

Thanks for the review.

Reload the page if you want to take the exam again. If you want to do video based Network+ training then please check out our Network+ Training Course.

1. Routed protocols include?

Question 1 of 50

2. Order the DHCP process correctly.
  • DHCP ACK
  • DHCP Offer
  • DHCP Discover
  • DHCP Request

Question 2 of 50

3. A modern variation of STP is?

Question 3 of 50

4. ___ is the latest SNMP version, which offers advanced security features, including authentication and encryption; this is the recommended version to be used in production environments.

Question 4 of 50

5. Switches that should exchange VLAN information must be configured with which of the following identical parameters?

Question 5 of 50

6. FTP uses which two ports?

Question 6 of 50

7. The below image illustrates which type of routing?

Question 7 of 50

8. Which command produced the below output?

Question 8 of 50

9. The below wiring indicates which type of cable?

Question 9 of 50

10. VoIP communications have some particularities that require specific protocols to handle different aspects of the process. In this regard, which two protocols are of interest?

Question 10 of 50

11. The three different categories of wireless SSID are?

Question 11 of 50

12. IPv6 addresses are ___ bits long.

Question 12 of 50

13. Match the correct command for the operating system.
Windows
traceroute

Unselect

tracert

Unselect

traceroute

Unselect

Linux
traceroute

Unselect

tracert

Unselect

traceroute

Unselect

Cisco IOS
traceroute

Unselect

tracert

Unselect

traceroute

Unselect

Question 13 of 50

14. D in Hex is equal to what in binary and decimal?

Question 14 of 50

15. TFTP is an unreliable file transfer protocol that functions over ___ port __.

Question 15 of 50

16. Distance vector protocols include?

Question 16 of 50

17. The below illustrates which type of routing?

Question 17 of 50

18. You can't use DHCP to allocate IP addresses to router interfaces.

Question 18 of 50

19. FE80::/10 range is used for which type of IPv6 address?

Question 19 of 50

20. Some common sources of interfaces for wireless networks include?

Question 20 of 50

21. The IPv6 loopback address is?

Question 21 of 50

22. Distance Vector protocols function using the “routing by rumor” technique, as every router relies on its neighbors to maintain correct routing information.

Question 22 of 50

23. STP calculations are based on which two key concepts?

Question 23 of 50

24. IPv4 Class D is reserved for defining Multicast group addresses. What is the range?

Question 24 of 50

25. A significant disadvantage of using satellite connectivity is the ____ ?

Question 25 of 50

26. You capture the below packet. What type of traffic are you sniffing?

Question 26 of 50

27. Which command produced the below output?

Question 27 of 50

28. Networks hubs operate at OSI layer?

Question 28 of 50

29. STP calculations are based on two key concepts. Name them.

Question 29 of 50

30. _______ functions by appending a label to any type of packet.

Question 30 of 50

31. Protocols designed to use with IPv6 only include?

Question 31 of 50

32. The below connector type is?

Question 32 of 50

33. An IPv6 address is ____ bits long.

Question 33 of 50

34. Tick the ranges of private IP addresses (RFC 1918).

Question 34 of 50

35. These addresses identify a group of devices in a network.

Question 35 of 50

36. HTTP operates on?

Question 36 of 50

37. In terms of crosstalk, this interference is measured at the transmitting end. This is one of the most relevant measurements, as the signal is the strongest near the transmitting end.

Question 37 of 50

38. Category 3 cable is associated with?

Question 38 of 50

39. One of the first and most basic steps in the Layer 3 troubleshooting process is verifying the IP address and other associated parameters of the local interfaces. Which Linux command would you use?

Question 39 of 50

40. Application layer protocols include?

Question 40 of 50

41. Routers block Multicast and Broadcast packets by default.

Question 41 of 50

42. Automatic Private IP Addressing (APIPA) addresses range from?

Question 42 of 50

43. Which type of connector is shown below?

Question 43 of 50

44. The below image is which type of tool?

Question 44 of 50

45. Which solution is required to allow internal hosts to reach the internet?

Question 45 of 50

46. Uses AAAA DNS records instead of A records (IPv4).

Question 46 of 50

47. The protocol data unit (PDU) at layer 2 is known as a?

Question 47 of 50

48. WLANs rely on the ______ mechanism.

Question 48 of 50

49. _____ is a technology that allows switches to pass electrical power along with data on Ethernet cables.

Question 49 of 50

50. Address ____ is used to test whether TCP/IP is working on your device.

Question 50 of 50