Module 9 Exam Back to Main Page 1. You can separate broadcast domains with? (choose all that apply) VLANsVTPRoutersSTPTrunk linksQuestion 1 of 15 2. Which VLAN numbers are NOT available to use? 100110021003100410051006Question 2 of 15 3. Which options would you expect to see after the ? (choose all that apply) Switch(config-if)#switchport mode ? accessdynamictrunkautosecuremasterQuestion 3 of 15 4. A trunk link can also be used to carry traffic between? (choose all that apply) Two switchesA switch and a serverA switch and a routerA switch and a PCA router and a routerA PC to PCQuestion 4 of 15 5. 802.1Q was created by Cisco as a standard for tagging frames. TrueFalseQuestion 5 of 15 6. In order for a trunk link to form, the native VLAN must match on both sides of the link. TrueFalseQuestion 6 of 15 7. The possible modes for a trunk link are? (choose all that apply) OnOffNo-negotiateDesirableAutoMasterBackupQuestion 7 of 15 8. Tick which of the switch to switch combinations that will result in a trunk forming between them. (choose all that apply) Auto - AutoAuto - DesirableDesirable - OnAuto - OnDesirable - DesirableQuestion 8 of 15 9. Which command will generate the below output? Name: Fa0/1 Switchport: Enabled Administrative Mode: dynamic auto Operational Mode: down Administrative Trunking Encapsulation: dot1q Operational Trunking Encapsulation: native Negotiation of Trunking: On Access Mode VLAN: 1 (default) Trunking Native Mode VLAN: 1 (default) Switch#show interface f0/1 layer 2Switch#show interface f0/1 switchportSwitch#show interface f0/1 switchSwitch#show ip interface f0/1Switch#show interface f0/1Question 9 of 15 10. Dynamic Trunking Protocol (DTP) is a Cisco proprietary point-to-point protocol. TrueFalseQuestion 10 of 15 11. The two possible DTP modes are? Dynamic desirableDynamic autoDynamic secureDynamic masterDynamic slaveDynamic onQuestion 11 of 15 12. Which of the DTP settings will NOT result in a trunk link forming? Auto - DesirableAuto - AutoNonegotiate - TrunkStatic Access - TrunkDesirable - OnQuestion 12 of 15 13. Which command will name your VLAN? Switch2(config)#vlan name ADMINSwitch2(config)#name ADMINSwitch2(config-vlan)#name ADMINSwitch2(config-vlan-name)#ADMINQuestion 13 of 15 14. Which of the following are correct about the native VLAN? (choose all that apply) 802.1Q tags frames with the VLAN ID but not the native VLANVLAN 1 is the native VLAN by defaultThe native VLAN must match on either end of a trunk linkYou cannot change the native VLANQuestion 14 of 15 15. Which commands are required to configure interVLAN routing on a router using sub-interfaces? (choose all that apply) R1(config)#interface fast0/0.10R1(config-subif)#encapsulation dot1Q 10R1(config-subif)#ip add 192.168.10.1 255.255.255.0R1(config-subif)#encapsulation dot1Q 10 nativeR1(config)#ip routingR1(config-subif)#switchport mode trunkQuestion 15 of 15 Loading...