Module 12 Exam Back to Main Page Please wait... 1. If one of the links in the Etherchannel bundle should fail for any reason, STP convergence will take place.TrueFalseQuestion 1 of 11 2. In order for an EtherChannel to form, all ports or interfaces should have matching settings including? (choose all that apply)speedduplexnative VLANtrunking statusDTP settingsQuestion 2 of 11 3. LACP is described in the IEEE _____ standard.802.3AD802.3A802.3AB802.3DQuestion 3 of 11 4. PAgP requires ports to operate in full-duplex mode (unlike LACP, which supports half-duplex).TrueFalseQuestion 4 of 11 5. LACP supports two modes of operations, which are _____ and ______.activepassivemasterslaveactiveautoQuestion 5 of 11 6. If both ends of a LACP link are in passive mode, then an EtherChannel will not be formed.TrueFalseQuestion 6 of 11 7. Just like LACP, PAgP sends packets between EtherChannel-capable ports to negotiate an EtherChannel. These frames are sent to the multicast address _________.01-00-0C-CC-CC-CC02-00-0C-CC-CC-CC01-00-0C-CC-CC-AA01-00-00-CC-CC-CCQuestion 7 of 11 8. Ports in auto mode will not initiate PAgP negotiation but will respond when they receive a PAgP packet.TrueFalseQuestion 8 of 11 9. You see the below command on a router. What has been configured? Switch0(config-if-range)#channel-group 6 mode desirablePAgPLACPSTPRSTP+Question 9 of 11 10. The port channel load balances traffic across its member interfaces on a per-flow method based on any of the sources and destinations below: (choose all that apply)Destination IPDestination MACSource and destination IPSource MACVLAN IDAccess List #Question 10 of 11 11. You want to create a layer 3 Etherchannel on your switch port. How do you convert it from layer 2 to layer 3?Switch(config-if)#no switchportSwitch(config-if)#switchportSwitch(config-if)#no ip addressJust add an IP addressQuestion 11 of 11 Loading...